Analisa Aliran Daya pada Sistem Tenaga Listrik menggunakan ETAP 12.6

Umar Faruq Al-afifi

doi:10.31849/sainetin.v6i1.7031

Umar Faruq Al-afifi Teknik Elektro Universitas Mulawarman, Samarinda Kalimantan Timur

DOI: https://doi.org/10.31849/sainetin.v6i1.7031

Keywords: Analysis, Load Flow, Electric Power System, ETAP

Abstract

Analysis of load flow in the Electric Power System is needed with the aim of improving and optimizing the system. This analysis can be carried out in various stages, either manually or with computer applications. Etap is one application that can be a tool for the analysis. Modeling the electric power system with ETAP Power Station 12.6 begins with analyzing the state of the system and then proceeds with Analysis and Actions to improve the state of the system. The advantage of simulation with ETAP Power Station 12.6 is that it can use 100% load. This research was conducted by utilizing ETAP Power Station 12.6 as a simulation medium with an electric power system that has 20 buses.

In this study using a power source in the form of a power grid or substation with a total capacity of 100 MVA. The data used for the analysis is using One Line Diagram, Channel Data and Load Data. Based on these data, a research was conducted using ETAP Power Station 12.6 for the study of power flow.

Downloads

Download data is not yet available.

References

N. K. Lal and S. E. Mubeen, “A Review on Load Flow Analysis,” International Journal of Innovative Research & Development, vol. 3, no. 11, pp. 337–341, 2014.

T. Gonen, Modern Power System Analysis, 2nd ed. Boca Raton: Taylor & Francis, 2013.

J. D. Glover, T. J. Overbye, M. S. Sarma, and T. J. Overbye, Power System Analysis and Design, SI Edition, 6th ed. Boston: Cengage Learning, 2015.

J. J. Grainer and W. D. Stevenson Jr, Power System Analysis, 5th ed. New York: McGraw-Hill, 1994.

F. Atmajaya, “Analisa Keandalan Sistem Distribusi 20 kV PT. PLN (Persero) Area Pelayanan Jaringan (APJ) Pontianak Metode Reliability Network Equivalent Approach (RNEA),” Jurnal Teknik Elektro Universitas Tanjungpura, vol. 1, no. 1, pp. 1–9, 2019.

A. Van Anugrah, H. Eteruddin, and A. Arlenny, “Studi Pemasangan Express Feeder Jaringan Distribusi 20 kV Untuk Mengatasi Drop Tegangan Pada Feeder Sorek PT. PLN (Persero) Rayon Pangkalan Kerinci,” SainETIn, vol. 4, no. 2, pp. 65–71, 2020.

H. Eteruddin, M. Mutamalikin, and A. Arlenny, “Perencanaan Sistem Distribusi 20 kV Di Sungai Guntung Kabupaten Indragiri Hilir-Riau,” Jurnal Inovasi Penelitian, vol. 2, no. 6, pp. 1863–1872, 2021.

H. Hendry, H. Eteruddin, and A. Atmam, “Analysis of Voltage Sag Due to Short Circuit on the Sub System in Central Sumatera,” International Journal of Electrical, Energy and Power System Engineering, vol. 1, no. 2, pp. 1–5, 2018.

M. F. Faisal, “Power Quality Issues & Case studies,” no. November, pp. 1–30, 2006.

T. J. Dionise, “Harmonic Filter Analysis and Redesign for a Modern Steel Facility with Two Melt Furnaces Using Dedicated Capacitor Banks,” vol. 00, no. September 2003, pp. 137–143, 2006.

A. Supriyadi, “Analisa Aliran Daya Pada Sistem Tenaga Listrik Menggunakan Software ETAP 12.6,” Forum Teknologi, vol. 6, no. 3, pp. 56–65, 2018.

J. Effendi, “Analisa Aliran Beban pada Sistem Tenaga Listrik di Pusat Penampung Produksi Menggung Pertamina Asset IV Field Cepu Menggunakan Software Etap 12.6,” Diploma Thesis, Teknik Elektro Universitas Muhammadiyah Surakarta, 2018.

B. Tri Wibowo, S. Setiawidaya, and M. Muksin, “Simulasi dan Analisis Load Flow Sistem Interkoneksi Kalimantan Timur Mneggunakan Software ETAP 12.6,” in Conference on Innovation and Application of Science and Technology (CIASTECH), 2018.

Y. Yolnasdi, F. Palaha, and J. Efendi, “Perencanaan Penempatan Recloser Berdasarkan Gangguan di Jaringan Distribusi 20 kV Menggunakan ETAP 12.6,” SainETIn, vol. 5, no. 1, pp. 27–34, 2020.

L. Multa and R. Prima Aridani, Buku Modul Pelatihan ETAP. Yogyakarta: Universitas Gadjah Mada, 2013.