Analisis Kelayakan Pemasangan Load Break Switch Motorized Pada Penyulang Anoa Di PT. PLN (Persero) ULP Rumbai
DOI:
https://doi.org/10.31849/qg8bck08Keywords:
Load Break Switch Motorized Keandalan SistemAbstract
Disturbances in the distribution system cause energy losses and reduce the quality of electricity services. This study aims to analyze the feasibility of installing a Motorized Load Break Switch (LBS) to improve the reliability of the distribution system on the Anoa Feeder at PT PLN (Persero) ULP Rumbai. The method used in this study is simulation using ETAP software to compare the reliability indices of SAIDI, SAIFI, and ENS before and after the installation of the Motorized LBS. The results show that after the installation of the LBS, there was a decrease in SAIDI by 73%, SAIFI by 89%, and ENS by 70%, resulting in a reduction of financial losses from IDR 88,438,619 to IDR 25,920,330 per year. In conclusion, the installation of the Motorized LBS is feasible to implement to improve the reliability of the distribution system and reduce losses due to power outages.
References
[1] Adi, Muhammad Taufiq. 2014. “System Monitoring LBS Motorized / Recloser For Power Companies Of SCADA System On Air Duct Medium Voltage (20kV).” Jurnal International.
[2] Ario Putra, Firdaus. 2017. “Analisa Penggunaan Recloser Untuk Pengaman Arus Lebih Pada Jaringan Distribusi 20 kV Gardu Induk Garuda Sakti.”, Jom Fakultas Teknik Vol 4 (No 1): 1–10.
[3] Arnawan Hasibuan, Andik Bintoro, Salahuddin, Rizka Dwi Meutia. 2022. “Reliability Distribution System On Load Break Switch Addition At PT . PLN (Persero) ULP Langsa City Using Ria- Section Technique Combined Method On Etap 14.1.0,” AIJASET Vol.02 (No.02): 4–11.
[4] Fitrindha Nurwulan, M. Ibnu Choldun R. 2020. “Jurnal Ilmiah Manajemen Informatika.” Ilmiah Vol.12(No.1): 1–39.
[5] Gonen, Turan. 2014. "Electric Power Distribution Engineering". CRC Press Taylor & Francis Group. Boca Raton London New York
[6] Haryantho, Junto Dennis, and Hanny Hosiana Tumbelaka. 2017. “Analisa Keandalan Sistem Kelistrikan Di Daerah Pelayanan PT. PLN (Persero) Area Timika Berbasis SAIDI, SAIFI”. Jurnal Teknik Elektro. Vol.10 (NO.2): Hal 71-74.
[7] Hayusman, Lauhil Mahfudz, Taufik Hidayat, and Choirul Saleh. 2017. “Pelatihan Software ETAP (Electrical Transient Analyzer Program)”. Industri Inovatif Vol 7(No 1): 7–11.
[8] Hendrik Kenedy Tupan, Rini Nur Nurhasanah, Wijono. 2017. “Optimalisasi Penempatan Load Break Switch (LBS) Pada Penyulang Karpan 2 Ambon Menggunakan Metode Algoritma Genetika". EECCIS Vol 11 (No 1): 1–8.
[9] Illahi, Hayatul, and L M Noveri. 2017. “Analisa Dan Evaluasi Penggunaan SCADA Pada Keandalan Sistem Distribusi PT . PLN (Persero) Area Pembagi Distribusi Riau Dan Kepulauan Riau”. Jom FTEKNIK Vol.4 (No.1): 1–8.
[10] K. Julianto, Deny Wiria Nugraha, A. Y. Erwin Dodu. 2014.“Evaluasi Penggunaan SCADA Pada Keandalan Sistem Distribusi.” Metrik Vol.1 (No.1).
[11] Rizal A. Duo. 2020. “Analisis Penyebab Gangguan Jaringan Pada Distribusi Listrik Menggunakan Metode Fault Tree Analysis Di PT. PLN (Persero) Rayon Daya Makassar.” Vertex Elektro Vol 12(No 02).
[12] Siburian, Jhonson M, Thamrin Siahaan, Johannes Sinaga, and Universitas Darma Agung. 2020. “Dengan Metode Thermovisi Jaringan PT. PLN (Persero).” Teknologi Energi Dua Vol.9 (No.1): 8–19.
[13] SPLN-68-21986. 1986. “Tingkat Jaminan Sistem Tenaga Listrik.” : Hal 9.
[14] Sukadana, I Wayan, and I Nyoman Suartika. 2019. “Optimalisasi LBS Motorized Key Point Pada Jaringan Distribusi 20 kV Untuk Meningkatkan Keandalan Sistem.” Seminar FORTET (Universitas Pendidikan Nasional (Undiknas) Denpasar): 141–49.
[15] Syafar, A.Muhammad. 2018. "Penentuan Indeks Keandalan Sistem Distribusi 20 kV Dengan Metode FMEA(Failure Mode Effect Analysis)". Kota Makasar. Penerbit Rizky Artha Mulia.
[16] Syarifah, Rudi Kurniawan, Asmar. 2021. “Analisis Kelayakan Pemasangan Load Break Switch (LBS) Di Penyulang Rindik Pada Proses Manuver Antar Penyulang Di PLN ULP Toboali”. Jurnal Electron Vol.2 (No.1): 48–56.
[17] Watingsih, Tri. 2012. “Sistem Jaringan Distribusi Tegangan Menengah.” Journal Article Vol.13 (No.2): 75–83.
